• Designed for the Evoltuion D5 Ranger and Maverick Models
• Max Amperage 15amps
• Birdie Pro FRONT Add-On Power Harness Allows Users to Easily Power Golf Cart LED Lighting or any 12-Volt Accessory Without Having to Splice into the Golf Cart’s Factory Wires
• This is the FRONT HARNESS that is used under the dash, and should only be used for Low Amperage items like LED lights.
• This pairs well with our Birdie Pro Garage Door Openers as it provides the 12v power for the lighted switches. 
• See our REAR HARNESS for things like Amplifiers, Powered Subwoofers, and other Sound Equipment
• Designed Specifically for Evolution D5 Golf Carts EV
• Features easy connect adaptors with 24″ Lead Wiring – Simple Plug & Play Connectivity in less than 10 minutes. 
• This is a great power source when used with our Garage Door Openers, Audio Harness and other lighted accessories.
• Step-By-Step Installation Instructions listed below

Instructions: 

*** MAKE SURE CART IS TURNED OFF AND NO POWER IS APPLIED TO THE SCREEN

1. Remove Center Glove Box by removing the 2 screws, then lift and tilt the glove box to remove it from the dash

2. Look for 4 Pin Wire Harness that has the wires labeled 83, 62A, 13B, 68. This is the existing 12v Harness that takes power to various accessories. 

3. Disconnect the Factory Harness and separate the Male and Female Side. 

4. Take the Birdie Pro Front Harness, and Plug the Female Side into the existing Factory Male Side. And then Plug the Male Side into the existing Factory Female Side. 

5. Connect the 24″ Red Wire coming from the Birdie Pro Harness to your 12v Positive / + connection (connectors included). 

6. Connect the 24″ Black Wire coming from the Birdie Pro Harness to your 12v Negative / – connection (connectors included). 

7. Zip Tie wires up to keep them from hanging near any moving parts (pedal, brake, etc). 

8. Test to make sure you are getting 12v from the lead wires. It’s best to test with a continuity tester first and make sure that between the Black Wire and any Ground, that you have continuity. Then use the Voltage Setting on your tester, and test between the Red Wire and Ground, and you should have at least 12 volts. If this is not correct, please check all of your connections and make sure you do not have the Blue Connections reversed. 

9. Replace Glove Box and install 2 screws. 

10. Enjoy your Birdie Pro Harness! 

Notes: Birdie Pro and Motomentum do NOT assume any responsibility for the installation of any of their products. If you do not feel comfortable installing this or any Birdie Pro product, please consult a professional Golf Cart Mechanic or Shop.